Precautions in the use of cold bending m

　　With the continuous development of China's industry, cold forming technology has also been rapid development. Cold bending machinery equipment has become an indispensable machinery in some professional factories. So the use of cold bending machinery and equipment also need to pay attention to the place.

　　First of all, we should choose a flat table, put the machine stable, you can open the chassis foot so that the machine panel is easy to observe. Insert the plug of the hand-held sensor head into the socket on the panel and tighten it, paying attention to the positioning gap.

　　Secondly, plug one end of the power cord into the socket on the back board of the case, and plug the other end into the power supply socket. Make sure to use single-phase three-wire power supply. Then open the "POWER switch (Power SW.)" on the back board of the case, press the panel "Switching" key, until the "WARM UP" green indicator light, the machine can work. Press and hold the "SETTING BUTTON (SETTING BUTTON)" BUTTON to set the appropriate value, generally between 0.5-2.0 seconds.

　　Once again the induction head on the container cover, press the start button on the handle, then the "HEATING" red light light, said that is HEATING, induction head do not move, "HEATING (HEATING)" red light removed after the induction head.

　　Finally, wait for the "WARM UP" green indicator light or the machine buzzer short sound "beep" prompt and then can carry out the sealing operation of the next container. Check the sealing quality, according to different materials, diameter of the container and production efficiency, appropriate dressing "SETTING BUTTON (SETTING BUTTON) BUTTON, so that the best sealing quality.